Fatal trap 12 when enabling wifi.

  • Hi.
    Sometimes immediately, sometimes after a few minutes when I have enabled my wifi the system crashes. In this example, the machine has been running for over a week, then I enable wifi and boom.

    2.0-RELEASE (i386)
    built on Tue Sep 13 18:02:53 EDT 2011 on a http://www.fit-pc.com/web/fit-pc2/fit-pc2i-specifications/

    Fatal trap 12: page fault while in kernel mode
    cpuid = 1; apic id = 01
    fault virtual address  = 0xc5e6c908
    fault code              = supervisor read, page not present
    instruction pointer    = 0x20:0xc084b582
    stack pointer          = 0x28:0xed028c48
    frame pointer          = 0x28:0xed028c74
    code segment            = base 0x0, limit 0xfffff, type 0x1b
                            = DPL 0, pres 1, def32 1, gran 1
    processor eflags        = interrupt enabled, resume, IOPL = 0
    current process        = 0 (run0 taskq)
    trap number            = 12
    panic: page fault
    cpuid = 1
    Uptime: 9d20h48m31s
    Cannot dump. Device not defined or unavailable.

    The wlan chip is:
    run0: MAC/BBP RT3070 (rev 0x0201), RF RT3020 (MIMO 1T1R)
    run0: firmware RT2870 loaded

    I have seen this thread, same computer with the same trap number error:

    Is there any known problems with this wifi-chip?

    How do I save coredumps when booting out of a usb-stick on a nanobsd-kernel? Can I mount another usb-stick and enable a core output on that device so I can backtrace the error?

  • Have you configured the WiFi interface as AP?

  • @wallabybob:

    Have you configured the WiFi interface as AP?


Log in to reply