USB RALINK
-
Actually it is missing. I went through the entire system.
-
Actually it is missing. I went through the entire system.
What do you mean by "I went through the whole system"?
Apparently you are doing something and interpreting the results as "missing run driver". I would like to know what you are doing and the raw (uninterpreted) results.
-
Before I send you the results I’m going to try the newest snapshot to see if that will correct the issue. I’m still hoping I can get this working properly. If not I may just give up and get a wireless AP and call it good until wireless N or the newest ralink 3070 drivers are supported. If not I’m wondering if I can compile the newest freebsd 3070 drivers and try those. Thoughts on the later?
http://forums.freebsd.org/showthread.php?t=7562
http://gitorious.org/run/run/trees/8.1_REL
-
Alright it's finally working again. The driver must not have been in the prior snapshot or something.
Now the problem is setting up the wireless to work properly. I have it serving out dhcp numbers, but the wireless clients cannot connect up to the webconfig. I have all of the firewall rules turned off while I’m trying to get this working properly. It is working perfectly when connected directly to the LAN port. I set it as an access point, assuming that this was the correct setting.
How I have it setup is:
LAN = 10.10.5.200
WiFi = None
Bridge = None (LAN + WiFi) -
I got it working actually. Now the only problem is the usb wireless card is dropping connections every so often.