Outgoing Nat port issues
-
I was doing some reading on this forum and the one fix that I saw was suggested didn't work.
I have tried checking "Enable advanced outbound NAT" under nat - outbound, then checking static port under the rule that gets created. It doesn't seem to help.
This is the issue I'm having.
NATTrace report (v1.01)
Generated: 9/13/2007 8:23:49 PM (9/14/2007 1:23:49 AM UTC)
Hostname: main
adapter: NVIDIA nForce Networking Controller #2 - Packet Scheduler Miniport
adapter: NVIDIA nForce Networking Controller - Packet Scheduler Miniport
addresses: 192.168.1.5
gateway: 192.168.1.1
adapter: MS TCP Loopback interfaceTests:
Test 1: SUCCESS - Connect to fixed IP
success
Test 2: SUCCESS - Check NATTrace version
success
Test 3: SUCCESS - Perform DNS lookup
success
Test 4: SUCCESS - Connect to named host
success
Test 5: SUCCESS - Direct TCP to fixed IP
success
Test 6: SUCCESS - Direct TCP (web) to named host
success
Test 7: SUCCESS - Direct TCP (6112) to named host
success
Test 8: SUCCESS - Direct UDP (6112) to fixed IP
success
Test 9: SUCCESS - Direct UDP (6112) to named host
success
Test 10: FAILED - NAT check, port 6112
NAT detected (Expected send on port 6112, went on port 53858 instead)
Test 11: SUCCESS - Direct UDP (port 9103)
success
Test 12: FAILED - NAT check, port 9103
NAT detected (Expected send on port 9103, went on port 57482 instead)
Test 13: SUCCESS - Direct UDP (port 30350)
success
Test 14: FAILED - NAT check, port 30350
NAT detected (Expected send on port 30350, went on port 53367 instead)
Test 15: SUCCESS - Direct UDP (port 30351)
success
Test 16: FAILED - NAT check, port 30351
NAT detected (Expected send on port 30351, went on port 56723 instead)4 tests failed
Any suggestions?
-
If you make that change and apply changes, that'll do it. You may want to try clearing the firewall state table.
-
I tried that and even rebooted with no luck.
-
these ports look extremly like supreme commander.
take a look at my thread about supreme commander in the game section.
i had the same problems but it works here with multiple static port rules for every single port .
(from top to down 5 rules)1:6112 static port yes
2:9103 static port yes
3:30350 static port yes
4:30351 static port yes
5: everything static port no -
Yea it is SupCom, and my old setup was m0n0wall and forwarding ports is different here then in m0n0wall but I will look for that thread. Thanks
-
That worked out for me, thanks for your help.