Newbie Help with configuring wireless card

[scopa]

Brand new to PfSense

Just got a netgate ALIX.2D13 and installed Atheros DCMA-82, CM-11

From the GUI after initial setup it does not see the wireless card. When looking at dmesg log it shows ath0 Atheros installed - no errors

From here how to I configure the WLAN and/or initialize the card?

Thanks,

SJ

[doktornotor]

Uhm… Tried Interfaces - Assign yet?

[scopa]

yup - Interface atho_wlan1 Mode Access Point

But does not show up under Interfaces assignments and I dont see where you configure the wireless settings

[doktornotor]

Kindly produce some screenshots of what you are doing.

[scopa]

attached two shots

If I add the ath0_wlan1 interface it adds it as OPT2 - do I go this route and then enable it? Just trying to see where I configure my WLAN settings.

Thanks,

[scopa]

Nevermind I see it now - just enable OPT2 rename and configure.

[doktornotor]

Yes. You need to assign the interface as already noted in my very first reply. (There's really no need to clone it unless you need multiple SSIDs.)