Help with Meraki MX64 client
-
I bought a Netgate 6100 and have 2 Broadband lines all working perfectly apart from one very annoying thing.
I have a Meraki MX64 which connects to a work VPN and it will not work.
I am no expert but have done a lot of reading and found its likely a NAT issue so have done the following. Changed the outbound NAT to Hybrid and added these rules. Interface WAN2 Source Network, IP of Meraki (static) destination any using the following ports 46462,9350,7351 with static port ticked on all of the entries.
I used the states to try and determine which ports I needed to use as my company were not forthcoming with the info.
It was working but after rebooting today it hangs, the Meraki shows a white light as connected but my device does not connect to the work VPN. Do not want to ditch pfsense but at the moment had to switch back to the USG.
Any ideas please ? Cheers in advance Jon