Keep Alive
-
@jknott Thank you for the suggestion. How do you run a shell script from the pfsense GUI?
-
You don't. You run it from the command prompt, though you may be able to have it start automatically on boot up.
-
@jknott Thanks! I see now there is a Shellcmd Configuration package that can be installed and used to run it. Will see how it goes.
-
That may do it. Also, that script is set for 50 seconds per cycle. You can adjust that as needed.
-
@jknott Well the command works but it didn't keep the device connected. Not sure what other commands I can use since pinging it every minute didn't work.
-
Do you know what's required to keep is alive? If all else fails, you can use my script to test for failure and send a wake on LAN frame.
-
@jknott No its a timeclock and the company provides no instruction. Already contact them and they know its an issue that they have not corrected...... https://www.icontime.com. I added your ping script through the GUI shell package. Not sure how to send wake on LAN frame.
-
@biggreydog alright I added the cron package and added a WOL command every hour on the hour.. not let's see this thing work now!
-
You could probably just run fetch against it to establish a connection periodically. Assuming it has an http interface.
You might find WoL does nothing. Until it's actually gone off at least.
Steve
-
There's no point in running WoL until it fails to respond to my script.
-
@stephenw10 It has an http interface. I'm not familiar with fetch. What command would I use?
-
Just pull a page from it, so maybe:
fetch http://<timeclock_IP>/index.html > /dev/nullSteve
