Routing specific traffic to OpenVPN connection

[tabtab]

Hello there,
I have set up a OpenVPN client in pfSense and I'd like to redirect all traffic from LAN to internet through this OpenVPN tunnel.
To do this, I have followed :

• This howto
• This howto

The two sites are giving almost the same configuration, but my setup don't work.

When I go to ifconfig.co, I still had my ISP public IP in place of the VPN provider's public IP.

My OpenVPN client tunnel is OK :
login-to-view

I have setup an interface as mentionned in the howto :
login-to-view

I have setup a gateway :
login-to-view

Created a firewall rule like this :

login-to-view

I rebooted pfSense to be sure, but same result.
What should I check to make this work ?

Thanks !

[tabtab]

Forgot to mention the Outbound NAT rule :
login-to-view

[viragomann]

@tabtab
Basically it should work with this rule as long as there is no floating rule overriding it.

Maybe you had an already opened connection as you did the IP check?

[tabtab]

Hello @viragomann,
I don't have any floating rule.
To be very very sure, I restarted pfSense and my PC, same result...
I really don't understand, it's no complex configuration...
Thanks !

[viragomann]

@tabtab
Check out Status > Gateways, fi the VPN gateway online.
If it's not, the rule is omitted for sure.

[tabtab]

@viragomann You're totally right !

The gateway was marked as down but ping to 1.1.1.1 from it works.
I changed the monitor IP, the gateway goes to UP and the traffic is OK

Many many thanks ;)