Netgate 2100 Vlans With Aruba 1930 Switch And AP15

[Derek_NOS]

Yes I have an allow all rule currently

[rcoleman-netgate]

@derek_nos Run a packet capture on the VLAN interface (Diagnostics->Packet Capture), change the capture size from 100 to 0, then have your devices attempt to get DHCP.

When they timeout stop the pcap. You'll get a small summary of the packets that the pf saw.
If there's nothing there (at all) it's probably a vlan issue.

have you tried bypassing the Aruba switch and plugging the AP15 directly into the 2100 (with a POE injector)?

[Derek_NOS]

So no info in when trying to get dhcp

[Derek_NOS]

do I need to select the port the Aruba switch is hooked up to?

[rcoleman-netgate]

@derek_nos I recommend you review this document and make the specific changes: https://docs.netgate.com/pfsense/en/latest/solutions/netgate-2100/switch-overview.html

[Derek_NOS]

@rcoleman-netgate this could definitely be the issue, how do I do this when there is multiple vlans going out one port?

[rcoleman-netgate]

@derek_nos Look at the 802.1Q section about tagging VLANs on ports.

[Derek_NOS]

@rcoleman-netgate I have my switch plugged into LAN1 and yes I see to switch the port vid to the vlan number but I also need the deault vlan 1 sent to the switch as well... How do I do this? I might be stupid but not getting how to send native vlan1 and vlan30 to LAN1

[rcoleman-netgate]

@derek_nos This is what I have mine set up as:

[Derek_NOS]

so the following should be fine for native vlan1 and vlan30

[rcoleman-netgate]

@derek_nos said in Netgate 2100 Vlans With Aruba 1930 Switch And AP15:

so the following should be fine for native vlan1 and vlan30

Yep!