No link when LAN connects to Cisco Switch
-
Can you connect em0 to any port on the switch?
How long is the cable? Can you use something shorter?It sounds like a failing port at one end. Anything using em is probably quite old.
Steve
-
@stephenw10 I've tried 2 of 48 with no success on the Catalyst, but em0 does connect to the Linksys no problem. Its a 12 year old Supermicro D525, so physical failure is not out of the question. Not sure why it would negotiate no problem with a 1 year old Linksys but fail to detect a 10 year old Cisco, maybe improved protocols?
-
Mmm, something nearing failure I'd guess. Probably a power component somewhere. Unlikely something repairable though. Can you try a different NIC?
Steve
-
Could it be that the Cisco Port needs mdix auto ?
/Bingo
-
Worth checking if that somehow got disabled. All Gigabit devices should be auto-MDIX though.
You might also try linking it at 100Mb fixed as a test.
-
I've enabled auto-MDIX and tried on a port set to 100 on the Cisco, also, 4 of 48 ports (100% of those tested) show no activity or link when connected to em0/LAN on pfsense.
I've also replicated similar behavior when connecting em0/LAN to a Brocade ISX6610 of similar age. Seems something about these old switches doesn't agree with em0 on my pfsense.
No problems when conmecting em0 to a recent Linksys router, other than not being an ideal setup.
A new nic should arrive today, then I'll see if that works better than the onboard for connecting to my old switches. Open to any other suggestions.
-
Has em0 somehow been set to a fixed speed/duplex?
-
@stephenw10 you may be on to something, "Speed and Duplex" are set to "default (no preference, typically auto select)" on the "Interface / LAN (em0)" tab, but my main dashboard reports "LAN 100baseTX <full-duplex>"
I set em0 to "autoselect", same behavior, same results.
I set the switch port I connect em0 on to 1000/full duplex and did the same for em0... that made em0 responsive no matter what it was plugged into (old cisco and brocade, new linksys)
I was able to restore my previous config and connect em0 back to the new linksys at "100baseTX <full-duplex>", and that's apparently when I stand until I can try out this new NIC - its an Intel 82576 chipset, so hopefully a smooth transition.
-
Installed the new NIC, LAN is set to "autoselect" and reporting "1000baseT <full-duplex>". Seems like it was bad/dying hardware.
Thanks for the help/suggestions.
-
Ah, that sounds like it's missing some lines and the linksys can detect that and fall back to 100M, which only needs two pairs. If that is the case then setting 100M fixed at both em0 and the Cisco switch should also link. If that does work then you are losing some connections somewhere. If not the cable then it could be in the port perhaps?
Steve
