PfSense 2.3.2 Ipsec site to site ok but can't access LAN
-
Hello
My site to site VPN Ipsec is ok but I can't access any LAN addresses or get my internet traffic Site 1 to Site 2, No ping either (lan)
My configuration :
Pour le Site 1 :
VPN > IPsec > Tunnels >Key Exchange version : V2
Internet Protocol : IPV4
Interface : WAN
Remote Gateway : IP Public (failover ESXI)Phase 1 :
Authentification Method : Mutual PSK
My identifier : Ip adresse public de la box (Site 1)
Peer identifier : Peer IP address
Pre- Shared Key :
Encryption Algorithm : AES 256 bits
Hash Algorithm : SHA 256
DH Group : 2 (1024bit)
Lifetime : 3600
Dead Peer Detection : Enable DPD
Delay : 10
Max failures : 20Phase 2 :
Mode : Tunnel IPV4
Local Network : 192.168.100.0 / 24
Remote Network : 0.0.0.0 / 0
Protocol : ESP
Encryption Algorithms : AES256-GCM Auto
Hash Algorithms : None
PFS key group : 2 (1024 bit)
Lifetime : 3600Pour le Site 2 :
VPN > IPsec > Tunnels >
Key Exchange version : V2
Internet Protocol : IPV4
Interface : WAN
Remote Gateway : IP Public de la box (Site 1)Phase 1 :
Authentification Method : Mutual PSK
My identifier : Ip adresse public (failover ESXI)
Peer identifier : Peer IP address
Pre- Shared Key :
Encryption Algorithm : AES 256 bits
Hash Algorithm : SHA 256
DH Group : 2 (1024bit)
Lifetime : 3600
Dead Peer Detection : Enable DPD
Delay : 10
Max failures : 20Phase 2 :
Mode : Tunnel IPV4
Local Network : 192.168.2.0 / 24
Remote Network : 192.168.100.0 / 24
Protocol : ESP
Encryption Algorithms : AES256-GCM Auto
Hash Algorithms : None
PFS key group : 2 (1024 bit)
Lifetime : 3600On the both sides i have the rules on Firewall > Rules > Ipsec > TCP, UDP, ICMP Allow all