Installation on Infoblox 1550
-
Hey All,
I recently purchased an Infoblox 1550 with the intention of installing pfsense on it.
I used Rufus to create the bootable USB with serial output. I am able to boot to it and it appears to install fine to the internal sata disk but when I do a reboot and remove the USB nothing appears to happen apart from the standard infoblox POST.
I'm unable to access the Infoblox BIOS, do I need to flash them and if so is there any guidance on how?
If it's helpful at all here is the motherboard.
http://www.supermicro.com/products/motherboard/Xeon3000/3000/PDSMi-LN4_.cfm
The one installed has serial output only. I tried to boot to freeDos but was unable to do so on this machine, my guess is perhaps freeDos defaults to video output and not serial.
Copyright 2025 Rubicon Communications LLC (Netgate). All rights reserved.