SN200 Stormshield access to UART
-
Re: Install pfSense on Stormshield SN300
I have 2 firewalls from Stormshield one is SN200 and the other is SN150
My focus is on the SN200 since it has a Sata drive and bigger memory.
So I installed Pfsense , the SN200 is booting up with no errors.
To my surprise the serial command : cu -l cuau1 -s 19200
returns a "connected" message however it remains there forever no matter how many times I hit return key or the time I wait.
Exiting the serial is normal, going back to the main menu of pfsense is also fine. Only the connection to serial from bsd shell is impossible.
This issue is blocking the progress of testing the appliance, I checked on the BSD there are 2 serial ports available with 9600 bps I also tried those but into vain.Can someone let me know how to overcome this issue? Unless I enable to ethernet ports and configure my vlans or a bridge the appliance is useless.
My issue with the SN180 , it comes with microsd , never able to make it boot on that micro sd.
By the way I have an SN250 that is configured with Pfsense , also tried Opensense... The trick is always the configuration of the vlans and enabling the ports via the serial command.
I hope someone is willing to help.
Thank you in advance.
-
That's the renamed Netasq U30S right? So the same applies here with the unsupported switch?
Steve