wan settings

[ansarmehmood]

Hi all can someone point me in the right direction, i have been given the below details by my isp, leased line, do i have to input all these details in pfsense or just parts of it, if so where do i put these as when i select staic on wan side it only ask for ip address and subnet mask

WAN Subnet: 81.xxx.xxx.176
WAN Subnet Mask: /30
WAN IP: 81.xxx.xxx.178
WAN Default Gateway: 81.xxx.xxx.177

Routed IP's Network Number: 81.xxx.xxx.116
Routed IP Mask: /30
Routed First Host: 81.xxx.xxx.117
Routed Second Host: 81.xxx.xxx.118
Routed Last Host: 81.xxx.xxx.118
Routed Broadcast Address: 81.xxx.xxx.119

[viragomann]

@ansarmehmood said in wan settings:

when i select staic on wan side it only ask for ip address and subnet mask

The gateway is requested as well, either in the initial setup in the console or when you configure the interface in the GUI.
In the GUI click "Add new gateway", then you're able to enter it.

The routed host IPs can be directly used in port forwarding rules as destination addresses.