New to VPN's, please help me with config.

Neut

I am trying to set a site to site with OpenVPN. Both locations are using PfSense.
Central office is server with IP address 192.168.0.0/24
Remote office is client with IP address 192.168.254.0/24
Using shared key.

In the central office, I have set Peer to Peer (shared Key), UDP protocol, device tun, WAN interface, port 9998, AES-256-CBC and RSA-SHA256, ipv4 tunnel network is 10.0.6.0/24,
ipv4 remote network 192.168.254.0/24, enabled adaptive compression, with no ipv6 traffic.

In the remote office, I have set Peer to Peer (shared Key), UDP protocol, device tun, WAN interface, port 9998, AES-256-CBC and RSA-SHA256, ipv4 tunnel network is 10.0.6.0/24,
ipv4 remote network 192.168.0.0/24, enabled adaptive compression, with no ipv6 traffic.

In both firewall rules I have set WAN ipv4 UDP * * WAN Address 9998 * none VPN - An any/any rule
In both firewall rules I have set OpenVPN rule ipv4 UDP * * * * * none VPN - An any/any rule

The VPN connects fine, but no traffic will pass. Does abything stand out, that I am missing? I followed a video setup guide from here: https://www.youtube.com/watch?v=8f13lfnEKY8

Please post if any information is missing!

viragomann

Are both pfSense boxes the default gateway in their LANs?

Neut

Yes, both are the gateway device in their respective LAN's.

Central Office Server is GW 192.168.0.1
Remote Office Client is GW 192.168.254.1

Edit Central Office Server GW IP to correct value.

viragomann

@Neut:

In both firewall rules I have set OpenVPN rule ipv4 UDP * * * * * none VPN - An any/any rule

On OpenVPN interface you also need other protocols like TCP and ICMP. So change the protocol to any will meet your needs.

Neut

I have modified the Central office, and will modify the remote office tomorrow. Will post the results.

Neut

That was it. Thank you very much.