New to VPN's, please help me with config.
-
I am trying to set a site to site with OpenVPN. Both locations are using PfSense.
Central office is server with IP address 192.168.0.0/24
Remote office is client with IP address 192.168.254.0/24
Using shared key.In the central office, I have set Peer to Peer (shared Key), UDP protocol, device tun, WAN interface, port 9998, AES-256-CBC and RSA-SHA256, ipv4 tunnel network is 10.0.6.0/24,
ipv4 remote network 192.168.254.0/24, enabled adaptive compression, with no ipv6 traffic.In the remote office, I have set Peer to Peer (shared Key), UDP protocol, device tun, WAN interface, port 9998, AES-256-CBC and RSA-SHA256, ipv4 tunnel network is 10.0.6.0/24,
ipv4 remote network 192.168.0.0/24, enabled adaptive compression, with no ipv6 traffic.In both firewall rules I have set WAN ipv4 UDP * * WAN Address 9998 * none VPN - An any/any rule
In both firewall rules I have set OpenVPN rule ipv4 UDP * * * * * none VPN - An any/any ruleThe VPN connects fine, but no traffic will pass. Does abything stand out, that I am missing? I followed a video setup guide from here: https://www.youtube.com/watch?v=8f13lfnEKY8
Please post if any information is missing!
-
Are both pfSense boxes the default gateway in their LANs?
-
Yes, both are the gateway device in their respective LAN's.
Central Office Server is GW 192.168.0.1
Remote Office Client is GW 192.168.254.1Edit Central Office Server GW IP to correct value.
-
In both firewall rules I have set OpenVPN rule ipv4 UDP * * * * * none VPN - An any/any rule
On OpenVPN interface you also need other protocols like TCP and ICMP. So change the protocol to any will meet your needs.
-
I have modified the Central office, and will modify the remote office tomorrow. Will post the results.
-
That was it. Thank you very much.