Outbound NAT not working
-
I'm trying to setup outbound nat for a secondary ip pool. Internet provider gave me a list of IP's from a different pool that will route out of my original gateway. I created a Virtual IP / Other / WAN / Network. Put the IP pool in with /27. Set Outbound NAT to Manual. Edited the rule for the correct IP Pool / VLAN and changed the NAT address to the Virtual IP / Network I created. Set it to Round Robin with Sticky Addresses.
I have an Any Any rule set for that VLAN and made sure it works fine with the NAT address set to the WAN address. When I change it to the new Pool the machines on the vlan can't get out. I can ping the gateway and the original Gateway address. If I try to ping Google or Spiceworks.com or anything DNS resolves find as it will show the IP but then fails to ping with Request Times Out.
If I change the NAT Address back to WAN Address / Interface Address it works fine.
What am I missing to get the outgoing traffic to show up as the new IP addresses?
-
@tobornimda said in Outbound NAT not working:
Internet provider gave me a list of IP's from a different pool that will route out of my original gateway. I created a Virtual IP / Other / WAN / Network. Put the IP pool in with /27.
If these additional IPs are not routed to your primary WAN IP by the ISP, you have to add each single IP out of the /27 subnet as a virtual IP to use it on pfSense.