Traffic through another wan, 2WAN 1LAN 1VLAN
-
@viragomann yes, in the failover group, if WAN1 goes offline WAN2 works fine.
however, even configuring this VLAN as a default gateway on my WAN2, it continues with the public ip of WAN1
-
@gdsf
Go to Status > Gateway and check if the WAN2 gateway is online. -
@viragomann yes :( if you want I can print other NAT or Firewall rules for you to have a better view
-
@gdsf
I'm not familiar with your language, but it seems to me that the status there says "not monitored".You have to enable gateway monitoring if using multiple WANs, otherwise the failover group don't work.
-
@viragomann It means that the link is up
-
@gdsf
Ok. Can you please post a sreenshot of Status > Gateways as requested? -
@viragomann here is the table
-
@gdsf
Why are there commas in the monitoring IP?
I don't expect that this can be used. -
@viragomann for some reason google translator put it, but when it left the native language it has dots
-
@gdsf
Google translator modifies a screenshot??So the WAN2 gateway is online, but traffic still goes out on WAN1 from VLAN10, even there is a policy routing rule. Or your outbound NAT doesn't work properly.
Can you post a screenshot a screeshot of the outbound NAT page, please?
-
-
@gdsf said in Traffic through another wan, 2WAN 1LAN 1VLAN:
I made an exit rule like this
That's the wrong interface. It must be WAN2.
-
@viragomann I did that, it still didn't work, I have a doubt, does the VIP need to be /29?
-
@gdsf
If you've got a /29 from the ISP you should set a /29 mask, of course.But if that's really an issue depends on the gateway, if it accepts packets from this IP.
If the gatway responses to pings you can simply try it out in Diagnostic > Ping.
You can select the VIP as source and send pings to the gw from it. -
@viragomann Do you know if there's a way to find this out?
I tried calling my provider but the service is terrible
I got access to the router but I don't know if it's possible to discover the range, but it has the ip, gateway and dns info
I did a test on the https://who.is/whois/ site and it said that my range is /8
-
@gdsf said in Traffic through another wan, 2WAN 1LAN 1VLAN:
Do you know if there's a way to find this out?
As said, ping with source option. Try the gateway and a public IP like 8.8.8.8.
You can capture the packets on WAN2 while pinging to see if pfSense uses the correct source. -
-
@gdsf
No, not this way. You have to state the VIP at source.
Your WAN IP is a private one as shown above. -
-
@gdsf
I got the idea, that the ping tool is not an appropriate way to test this. The ping requests might go out to the default gateway.You have to ping from a VLAN10 device. The policy routing rule should direct it out to WAN2 and it should get the VIP as source.
So sniff the traffic with packet capture while pinging to investigate if all these work.
