ARPwatch flip-flops on WAN interface
-
@stephenw10 The pfSense WAN interface.
-
@deanfourie your saying the mac address of your own physical interface is changing?
-
Or something else is using WAN IP. Though if that were the case I'd expect to see log entries complaining about it in the main system log.
Steve
-
@stephenw10 yes, that's what Arpwatch is reporting.
It's actually the IP address of the upstream gateway changing, not pfSense which in my case is a Huawawei 4G router.
hostname: <unknown> ip address: 192.168.1.1 ethernet address: 82:49:99:43:53:92 ethernet vendor: <unknown> old ethernet address: cc:e8:ac:92:53:43 old ethernet vendor: <unknown> timestamp: Thursday, February 23, 2023 8:27:41 +0000 previous timestamp: Thursday, February 23, 2023 8:27:28 +0000 delta: 13 seconds -
Your WAN IP address is 192.168.1.1? Not the gateway? That's unlikely.
-
@stephenw10 no, my WAN upstream gateway.
-
@deanfourie I have a 4G router which is my incoming internet connect to pfSense via ethernet which is setup as a WAN upstream gateway. Public IP address is on the 4G router, pfSense obtains a private IP address as its WAN address from the 4G router.
-
@deanfourie so your 4g device which is at 192.168.1.1, and pfsense gets some IP 192.168.1.X (not 1) and .1 mac address changes. or there is something else on this same network.
You have a cable that plugs from this device to pfsense wan? There is no switch between with other devices, or switch ports on this device your plugging pfsense into.
If there are multiple devices that say their IP is 192.168.1.1 - ie your seeing 2 macs for this same IP. Not sure what pfsense is suppose to do about it. Pfsense is just reporting that the mac for this IP is changing..
That 82:49 mac I can not find what maker that is.. that cc:e8 mac shows as..
Company SOYEA Technology Co.,Ltd. Address hangzhou zhejiang 310007 Jiaogong Rd.No.1 CHINA Range CC:E8:AC:00:00:00 - CC:E8:AC:FF:FF:FF Type IEEE MA-L -
@johnpoz yes this is an isolated network, no switch in between and no way someone could connect on the 1 network unless they physically plugged into the 4g router and set a static IP of 1.1.
This is strange
-
@deanfourie so it has more ports.. Does it have wifi.. What is the specific make and model of this device?
If it has multiple lan switch ports - did you try plugging into a different port.
-
Run a packet capture, see if you can get any traffic from the alternative MAC to find out what it is.
If the 4G router is doing any sort of bridging it might have more than one MAC.
-
@stephenw10 yea the WAN 4G router should no be doing any bridging as it is not in bridged mode.
I'll run a cap next time, I might have actually grabbed a cap I'll check
