Last IP of an Alias is not used???
-
@furom Create the alias and check its contents in Diagnostics/Tables.
-
@furom said in Last IP of an Alias is not used???:
Anyone else seeing this phenomena?
Nope... I looked in all of my per-existing aliases, and all the IPs are there. I then for good measure created a new one with 5 IPs, and all of them there.
-
@steveits said in Last IP of an Alias is not used???:
Create the alias and check its contents in Diagnostics/Tables.
Did that now, and as said before, I have defined it with same address twice at the end for it not to be blocked, but in diagnostics/table it only shows up once. But it shows 6 unique addresses, which is correct.
-
@johnpoz said in Last IP of an Alias is not used???:
created a new one with 5 IPs, and all of them there
Same here. In diagnostics/table all addresses show up, but for one of them pfSense is not using the last one - it is being blocked and cought in the log. Mitigation for now is to enter it twice in the alias...
-
@furom said in Last IP of an Alias is not used???:
I have defined it with same address twice
why.. its not going to show dupes I do not believe.. Here I created some dupe entry in my test alias. And a new one - to make sure its in there, etc.. So I added 192.168.6.100, as you can see none of the dupes are shown, but the 6.100 is there now along with the others.
-
@johnpoz said in Last IP of an Alias is not used???:
why..
Because if I don't, that address is blocked, despite being defined in the alias... of which all the rest of the addresses work as they should (aka is not blocked)
This whas the point of the question/post... I don't get why this last one does not get processed (or seems not to be).
-
@furom is it in the table? Remove your dupes of this IP, and look in the table..
-
@johnpoz said in Last IP of an Alias is not used???:
@furom is it in the table? Remove your dupes of this IP, and look in the table..
Removed it, reloaded filters just in case, and yes, all 6 addresses are still there. But now it gets blocked again. I have no real good way of testing if the last in each alias does the same, but would be interesting. I have only noted this one though
-
@furom Tried, can't duplicate.
Alias with 5 IPs in LAN subnet, mine last
rule allow ICMP to pfSense from alias
rule reject ICMP to pfSense from LAN NetCan ping. Removed the allow, waited for the state to expire, can't ping.
Interestingly, the test alias does not show up in Diag/Tables until it is used in a rule. Didn't expect that but it makes sense.
-
@steveits said in Last IP of an Alias is not used???:
@furom Tried, can't duplicate.
Alias with 5 IPs in LAN subnet, mine last
rule allow ICMP to pfSense from alias
rule reject ICMP to pfSense from LAN NetRemoved the allow, waited for the state to expire, can't ping.
Interestingly, the test alias does not show up in Diag/Tables until it is used in a rule. Didn't expect that but it makes sense.
Understood, and appreciated. As it has an easy workaround it's really not a big problem. Was just curious if anyone else had the same, and apparently not, which is all good. :) Thanks for testing!
