WAN wrong speed of PFsense 27 community ed ver 20230215-0600

[kubato]

I installed the latest dev. build (my first install of 27) and all went fine. The hardware is a Firebox T70 using ports 0 for wan and 1 for lan. It installed and worked correctly for the most part but, the WAN port 0 defaulted to 10/100 not Gig or 10/1000. I checked the interfaces and WAN (igb0) Speed and duplex was set to autoselect, I changed it to 1000baseT full-duplex and it changed and is working correctly. The install was based on pfSense-CE-memstick-serial-2.7.0-DEVELOPMENT-amd64-20230215-0600
Here are some info to assist you all. Since this is first install of Dev package on my backup Firebox T70, I had both wan and lan ports plugged into the same network switch so it appears to be some code in the on the WAN or igb0 interface software config.

Just trying to help you all out.... Thanks,