Proper way to restore configuration on new vm
-
@Bob-Dig Which means in practice, I need to firstly edit interface names on new VM to reflect interface names of old instance, and then only after doing that, I can restore desired backup from the old VM, right?
-
@dzonic90 its not difficult - check the mac addresses of the interfaces before you add a new one and what they are assigned too. then via console just hit 1 to assign interfaces and make sure they are all assigned correctly..
If it take you more than like 1 minutes I would be surprised.
Its best if you know your going to need more than 4 to add them from the git go, or you could just use vlans on the virtual interface you assign so that your not actually adding more virtual nics to the pfsense vm.
-
@johnpoz Thing is, when I do new interface, or do any change which causes to change interface assignments, I get my connection lost, so no console, no anything. It's a remote system on which I'm connected over VPN :)
-
J jimp moved this topic from Problems Installing or Upgrading pfSense Software on
-
@dzonic90 said in Proper way to restore configuration on new vm:
so no console, no anything. It's a remote system on which I'm connected over VPN :)
That is bad. Is the vm from the same hypervisor or is it different. How do you do this anyway, if you loose the connection?
-
@dzonic90 said in Proper way to restore configuration on new vm:
@johnpoz Thing is, when I do new interface, or do any change which causes to change interface assignments, I get my connection lost, so no console, no anything. It's a remote system on which I'm connected over VPN :)
advice: don't add interfaces to a pfsense-VM remotely
if you have to do it:
1)get someone on-site ready with a cellular hotspot that has direct connection to the hypervisor management interface
2)add the VM interfaces over this cellular link
3)open the VM console of your pfsense and reassign the interfaces -
@Bob-Dig It is the VM from the same hypervisor - also on the same hypervisor, VMWare ESXi.
I usually hoped for the best when doing such changes
Same with upgrades. -
@heper Yeap, this seems like the only way to do it.
Thanks! -
@dzonic90 said in Proper way to restore configuration on new vm:
It is the VM from the same hypervisor - also on the same hypervisor, VMWare ESXi.
Then you only have to create the exact same interfaces beforehand, should be doable.
-
How many interfaces do you have already? How many are you adding?
ESXi will reorder the NICs when you add more than 4.
-
@Bob-Dig I'm currently doing it in test env. Will see, I hope for the best.
-
@stephenw10 It has more, 8 or 9, something like that.
-
Hmm, I forget if it reorders again at higher numbers. But not the usual limit people hit though.
-
@stephenw10 Uhhh, wait, you mentioned NICs, I thought on interfaces. sorry. It has VLANs and other interfaces, altogether it makes 8-9, but NICs, it has 2 I think.
My bad. -
Ah, well still not hitting that then.
-
@stephenw10 Possible
