Double counting of WAN out traffic?
-
@stephenw10 I actually have PPPoE.
It is, of cause, expected that you can not reproduce this problem. Most of the bugs appear under the specific non-default conditions. This is because default and commonly used conditions tested before release. -
Bump as I'm also seeing this. Had it in 2.4, still happening in 2.5.
Wan is PPPoE. Outbound WAN traffic appears double in the traffic graph and in the value of ifOutOctets by SNMP. (Both compared to the interface on pfSense that the traffic is flowing to, and the traffic graphs generated by my ISP.) Inbound WAN traffic and all the other interfaces are unaffected.(I've been working around this in a script that collects SNMP data by dividing the value by two.)
-
I see the problem as well on 2.5.1.
I use PPPoE on VLAN tagged port with traffic shaping.
The WAN interface shows 22M during a speed test, which report 11M.
The DSLMODEM interface, where the DSL modem is connected, shows 11M upload at the same time, which is in line with my maximum upload speed as reported by the DSL modem.
When I remove the traffic shaping then the doubled upload bandwidth display on WAN goes away. -
Do you still see that in 2.6?
-
Yep, still happening for me in 2.6
-
Are you also running traffic shaping on the WAN?
-
Yes I am.
-
So pretty much exactly as described here?: https://redmine.pfsense.org/issues/11759
Except there is no mention of shaping there which is probably why Viktor couldn't replicate it.Steve
-
@stephenw10 I just wanted to highlight this issue is still present in 23.05.1
I also run a traffic shaper on WAN. What's not shown below are the three wireguard interfaces carrying the LAN2 traffic.
-
You should add your data point to the open bug report.
-
@stephenw10 done
