Package Manager not showing some packages

hauy

@bmeeks Yes. That is true. Can I uninstall it?

bmeeks

@hauy said in Package Manager not showing some packages:

@bmeeks Yes. That is true. Can I uninstall it?

I need a bit more info to give a definitive answer.

Do you see evidence of a previous install in config.xml when searching that file, or did the pkg info command show udpbroadcastrelay being present?

If the latter (pkg info showed it installed), then you can remove it with this command:

pkg remove pfSense-pkg-udpbroadcastrelay

If instead you see evidence in config.xml, that will likely require manually editing the file and removing those XML sections. Make sure you have a good backup of the original file before making any edits, though. Editing the config.xml file can be dangerous unless you are experienced with reading and understanding XML coding and formatting. If you delete the wrong sections or delimiters you can create a badly formed XML configuration and potentially render your firewall non-bootable.

hauy

@bmeeks The pkg info command did show udpbroadcastrelay being present.
So I'll try tor run the remove command and see if it will be in the list of available packages afterwards.

bmeeks

@hauy said in Package Manager not showing some packages:

@bmeeks The pkg info command did show udpbroadcastrelay being present.

Okay, use the most recently edited version of my last post to remove it. Use this command:

pkg remove pfSense-pkg-udpbroadcastrelay

There may be two parts installed: the GUI portion and a supporting binary. So use the pkg remove command to remove both if necessary, but generally removing the GUI package (the pfSense-pkg-udpbroadcastrelay) piece will be sufficient as that should also remove the binary portion.

hauy

@bmeeks Great! It worked. Thanks a lot for your help!

bmeeks

@hauy said in Package Manager not showing some packages:

@bmeeks Great! It worked. Thanks a lot for your help!

You're welcome!

hauy

@bmeeks Sorry, was a bit too early. Service seems not to be starting. Do I need to reboot?

bmeeks

@hauy said in Package Manager not showing some packages:

@bmeeks Sorry, was a bit too early. Service seems not to be starting. Do I need to reboot?

I may not be as helpful with non-starting as I am not very familiar with that package.

Look in the pfSense system log to see if any useful errors were logged. You can also search for relevant posts under the PACKAGES sub-forum. I've seen several referencing that package in the past.

Usually it is not necessary to reboot after installing a package. I would first check that all the required configuration settings are present and correct. Maybe some parameter is not set properly???

hauy

@bmeeks I figured it out. I deactivated and reactivated the service and it seems to work now. Thanks again for your help!

bmeeks

@hauy said in Package Manager not showing some packages:

@bmeeks I figured it out. I deactivated and reactivated the service and it seems to work now. Thanks again for your help!

That likely means some piece of the configuration was incomplete, and making that change and saving it caused the package GUI code to rewrite the configuration.