SG-3100 Install on M.2

[ccigas]

I am trying to repurpose my sg3100 but I want to install an m.2 to do so. I already have a recovery image, although old at 2.4.5 (pfSense-netgate-SG-3100-recover-2.4.5-RELEASE-armv6.img), I have used this image a few times in the past on the emmc storage. I ran the run recovery and installed to ada0 and then to boot to the m.2 I ran "setenv bootcmd 'run setLED; run m2boot;'" which it took but when I try booting, I get stuck on a the following.

Error: SCSI Controller(s) 1B4B:9215 1B4B:9235 not found
scanning bus for devices...
  Device 0: (1:0) Vendor: ATA Prod.: TS128GMTS430S Rev: 22Z2
            Type: Hard Disk
            Capacity: 122104.3 MB = 119.2 GB (250069680 x 512)
Found 1 device(s).
** Unrecognized filesystem type **
## Starting application at 0x00200000 ...

Couldnt find anything searching around for it so hoping someone can help me out.

Thanks!

[stephenw10]

Did you run saveenv after setting the bootcmd value?

You should open a ticket and get the current recovery image:
https://www.netgate.com/tac-support-request

[ccigas]

@stephenw10 yup I did.

Will open a ticket. Thanks

[Stickie]

I had the same issue and stumbled upon an older post noting that you need

setenv m2dev 1

which the documentation fails to mention.

I hope this saves anybody else some time.

[stephenw10]

Ah, yes if you don't have that set already (it should be) then it would need to be set.

[ccigas]

@Stickie

Thanks! Support actually sent me that this morning so going to give a shot later on. At least I know that helps.