Limiter Schedules don't Work

[Negan]

Hi, I’m having trouble on my Netgate 8200 with Limiters, Bandwidth Schedules.

I have 2 schedules set up, the problem that I am seeing is the Schedules don’t seem the apply, even though I can see which Schedule should be active.

The only way I can get the Schedule to swap to the active one is to go into the Limiter and press save, which kind of defeats the purpose of a schedule.

Thanks in advance for any help.

[JonathanLee]

@Negan have you checked your config.xml file to make sure something didn’t get saved by accident? I had an issue where my config.xml file had limiter info still saved in it but it was disabled in the gui. Check the file search for it and see if it is still listed.

Mine for a while was showing old settings for before my new 1gps fiber line was installed

Check the file

/cf/conf/config.xml

Reference the default config.xml to see how the traffic shaper was set with nothing on it.

/conf.default/config.xml

I have had this happen sometimes where something gets bonkered up

[Negan]

@JonathanLee

The config.xml seems fine, and I have double checked all my setting before I posted here, but thanks for the advise.

In the Diagnostics/Limiter Info show the current bandwidth set it never changes when the Schedule does, I have tested doing speed test to make sure which Bandwidth is been used, as in my first post it only changes when I press save in Limiter settings.
Thanks anyway.