pfsense sophos xg 85 setup issue
-
@stephenw10
yes I can enter the bios without any problems, I keep the usb I prepared for the preload order in the first place.I can also see the sophos disc.
I tried uefi and legacy, unfortunately it didn't work.
-
So it fails to boot USB? Does it show an error?
-
@stephenw10
The interesting part of the job is that I do not get an error, I quickly come up to the screen I posted the picture above and stay here. normally it should go through this screen quickly and continue loading pfsense.Honestly, I don't think there is a problem with my device, but I don't understand why the device suddenly became like this and no longer allows me to install
-
Can you get more screen shots or a video of exactly what you see?
-
@stephenw10
I was able to get to the installation screen in uefi mode, now I don't understand how it happened, but now I'm past that, but in the disc selection section, this time I get the following errorby the way, thank you very much for your help.
-
Does it offer the drive as an installation target?
Do you see the drive in the boot log?
-
@stephenw10
I see the disc gives an error when I select it to load
-
@firelord61 I think my disc's corrupted.
-
It could be the eMMC has gone read-only due to drive writes.
-
@stephenw10 can be fixed ?
-
Not if that is the case. eMMC has limited writes after which it will not allow further writes. It will fail and depending on the drive controller/firmware may at least fail gracefully to a read-only state.
It may not be that. Can you write to it with anything?
