Netgate 4200 - boot problems
-
Hmm, none of those errors would prevent booting. They are common and usually harmless. The WiFi drivers are not used and Unbound starts anyway.
Are you booting from eMMC or SSD?
If it happens again try to connect the serial console and see what's happening there.
Steve
-
@stephenw10
from SSD , but with Netgate 2100 (where I didn't have such a problems) I had also SSD built in. -
The 2100 is very different hardware. But obviously both device should boot normally. If there is nothing logged then only checking the console might show what's happening. Can you replicate it?
-
I appreciate this reply adds nothing in terms of troubleshooting content, but I too have had boot issues on my Netgate 4200 after using 'Halt System', with the same symptoms as you (status LED stuck at solid orange).
I did capture the logs via serial but discarded them after I switched to safe boot mode (from the boot options menu I believe), booted successfully, then rebooted in normal mode, as I thought it was a one-off issue. I did try Single User mode first but that too failed to boot.
Now I know it's happened to others, I'll capture the serial output if/when it happens again, and I'll keep an eye on this thread.
If it helps with any troubleshooting, only ~20 lines of output were observed after the boot menu before it stalled.
EDIT: To add, I'm using the 4200 MAX model, so I am booting from SSD rather than eMMC.
-
Hmm, odd. So you were still able to access the bios setup? It was trying to boot it sounds like but the LED never changed to blue?
-
@stephenw10 Yeah, that's right - it got to the boot menu, then the boot process started to scroll on the screen but stalled ~20 lines in, and it was always the same line it stalled on. I tried a full power drain too, but it still stalled at the same point.
I should have really saved the output from the session but as I say, I thought it was just a one-time oddity - sorry I don't have more info to provide, but if it ever happens again, I will make sure to save the output and post on the forums.
-
@stephenw10 Sorry for replying after almost one month (private reasons).
So it happened again about one week ago. So I connected to the console via USB, but there was no output there. The device just freeze with the solid orange circle led and nothing happened.
best regards
Tom -
Mmm, I wouldn't expect any output if it's in standby which is indicated by the orange LED.
Did it boot back normally after power cycling?
-
@stephenw10
After second power off and on yes. -
Can you replicate the failure with the console already connected? That may show why it's going to standby.