Update 2.7.2 to 2.8.0 Dynamic DNS not working with Cloudflare
-
@fireodo I added both services. Without any success
-
@stephenw10 Here is my output
-
@power_matz said in Update 2.7.2 to 2.8.0 Dynamic DNS not working with Cloudflare:
I added both services. Without any success
OHhh - so there must be, in your case, a other cause for not getting the pppoe0 adress ...
I have here also dyndns with pppoe but not with cloudflare as provider ... -
@stephenw10 said in Update 2.7.2 to 2.8.0 Dynamic DNS not working with Cloudflare:
Is everyone hitting this using pppoe by chance?
I have pppoe here too but not cloudflare dyndns - i guess its something specific to cloudflare ...
-
@stephenw10 same output here. it show my correct ip
i've tried the webpage also return the correct ip
@fireodo i've added both of sites, same result
-
Hmm, the error it's showing should be independent of the service in use. It tries to read the IP, checks its a valid IP address and fails that check.
I'm wondering if it's passing the wrong interface type after the pppoe changes hence asking if anyone is hitting it on a non-pppoe wan?
Also is anyone using using not the actual 'wan'? Like opt1, opt2 etc?
-
@stephenw10 Just to clarify: I am still using the old module, not the new if_pppoe kernel module for PPPoE client
-
Ok. It may still be the issue though as the pppoe code was changed to allow both connection types.
-
@stephenw10 Just configured another DynDNS Service and switched to the new if_pppoe kernel module. The problem is still there
-
Only after switching to if_pppoe?
Which interface are you using pppoe on? The actual 'wan' interface?
-
@stephenw10 before and after switching. Just wanted to confirm that the new if_pppoe module is not the culprit.
I am using the 'wan' interface -
Hello.
I am experiencing the same faulty behavior.
When debugging the PHP-Command in pfSense, it returns an IPv6 in my case. -
When querying
pppoe0? -
@stephenw10
Yes.
Still quite common in Germany. (V)DSL so it's based on pppoe.Dynamic DNS updates stopped working just as 2.8.0 was installed. Quite a bummer for me because I am heavily depended on that function.
I also tested it with the old pppoe driver and the new one - same behavior, despite I am not using cloudflare. -
Do you only have an IPv6 address there?
I'm using PPPoE over VDSL here and it work fine. There must be something else in play.
-
Is your upstream gateway shown as online?
In 2.8.0 (and 25.03) dyndns update will fail if the gateway is offline.
-
@stephenw10
Nope, it's dual stack (IPv4 and IPv6) -
@stephenw10
It's indeed offline.
I just changed it to unmonitored and, who would have thought, the DynDNS update is working again. -
@djstone
ok, I'll have to correct that statement - IPv6 worked. IPv4 shows "0.0.0.0" as IP. -
@djstone
I think the cause for the IPv4 address not updating might be, that I already did it via another service. Will restart the pppoe connection and see if it comes back to live correctly.
