7100 1U dead powersupply, replacement?
-
I've got a remote 7100 1U unit with a dead PSU. I'd like to revive it by replacing the power supply. Unfortunately I can't get out there to visually inspect the hardware to get Netgate ID or serial to verify exactly which version of the 7100 it is. I'm fairly certain the HA pair is identical and I have the backup unit's numbers, though. Perhaps there's only ever been one version of the 7100 PSU?
In any case, nobody is going out there again to check it so I'd like to be equipped with a replacement for my next visit. I'm hopeful there's a generic PSU I can stuff in there. Otherwise, does Netgate have spare parts for some of these older models?
I'd open a TAC ticket but like I said, I don't have the Netgate ID or serial. I have the most recent backup of the config but don't see those values in there. Any advice on how to proceed?
-
@Troutpocket
Did you see that thread?
https://forum.netgate.com/topic/179872/xg-7100-1u-psu/18
I think virtually any Flex ATX power supply with SATA power connectors will work.
You’ll only need that ATX switch wire, and some models can even operate without it. -
@w0w I don't know how that didn't come up in my search! Thank you. Netgate is actually going to send a replacement (for $$).
-
@Troutpocket said in 7100 1U dead powersupply, replacement?:
Netgate is actually going to send a replacement (for $$).
Good to know they have it, so how much is it?
-
@w0w $65 plus tax and shipping.
