SG-1100 Dead
-
My SG-1100 has provided me with many years of great service to only give up the ghost sometime during the night. No Lights, used a power supply from my second SG-1100 and still no lights.
The question here is, does anyone know how to get the configuration data out of it. I know sometimes components can be replaced to get items working again however I do not see any evidence of something going bad on the board. Please don't say I should have had backups I know better and last backup is from three months ago before I revamped its entire configuration. Stupid me I know. Any thoughts or suggestions would be appreciated before I take the next two days building from scratch. -
One of those LEDs is just hard wired across the input power so if even that isn't on it must be a component failure in the power circuit.
There's no way to access the eMMC on the board without power that I'm aware of. Not easily at least. I'm sure you read from it directly given the right equipment but it wouldn't be economic/practical.
I assume you didn't have auto config backup setup?
-
@stephenw10 Thanks for the info on the LED, luckily I had a 'spare' SG-1100 and was able to restore an older manual backup to get myself operational luckily not much changed since that backup. Looking at auto backup now. I will probably start probing the old one to see which component failed and see if possible to replace however at least for now im back up and running and 98% where it should be config wise just have to fix my Acme config before the end of the month and ill be happy.
Thanks!
-
If you think ACB was configured I can check for recent backups if you send me the NDI of the failed 1100 in chat.
