Unable to reinstall pfSense Plus via USB

rm-rf_

I recently picked up an SG1100 and I'm trying to reinstall the pfSense Plus Software via USB.

I can boot into uboot, when when I run run usbboot, usb reset; run usbboot, or run usbrecovery, I get the following messages and the device reboots:

Marvell>> run usbboot
resetting USB...
USB0:   Register 2000104 NbrPorts 2
Starting the controller
USB XHCI 1.00
USB1:   USB EHCI 1.00
scanning bus 0 for devices... WARN halted endpoint, queueing URB anyway.
Unexpected XHCI event TRB, skipping... (3f6b6ab0 00000000 13000000 01008401)
BUG at drivers/usb/host/xhci-ring.c:496/abort_td()!
BUG!
resetting ...

Model information is:

TIM-1.0
WTMI-devel-18.12.1-1a13f2f
WTMI: system early-init
SVC REV: 5, CPU VDD voltage: 1.248V
NOTICE:  Booting Trusted Firmware
NOTICE:  BL1: v1.5(release):1f8ca7e-dirty (Marvell-devel-18.12.2)
NOTICE:  BL1: Built : 10:16:46, Oct 13 2021
NOTICE:  BL1: Booting BL2
NOTICE:  BL2: v1.5(release):1f8ca7e-dirty (Marvell-devel-18.12.2)
NOTICE:  BL2: Built : 10:16:50, Oct 13 2021
NOTICE:  BL1: Booting BL31
NOTICE:  BL31: v1.5(release):1f8ca7e-dirty (Marvell-devel-18.12.2)
NOTICE:  BL31: Built : 10

U-Boot 2018.03-devel-18.12.3-gc9aa92c-dirty (Oct 13 2021 - 10:14:54 -0300)

Model: Netgate 1100
       CPU     1200 [MHz]
       L2      800 [MHz]
       TClock  200 [MHz]
       DDR     750 [MHz]
DRAM:  1 GiB
Comphy chip #0:
Comphy-0: USB3          5 Gbps
Comphy-1: PEX0          2.5 Gbps
Comphy-2: SATA0         6 Gbps
SATA link 0 timeout.
AHCI 0001.0300 32 slots 1 ports 6 Gbps 0x1 impl SATA mode
flags: ncq led only pmp fbss pio slum part sxs
PCIE-0: Link down
MMC:   sdhci@d0000: 0, sdhci@d8000: 1
Loading Environment from SPI Flash... SF: Detected mx25u3235f with page size 256 Bytes, erase size 64 KiB, total 4 MiB
OK
Model: Netgate 1100
Net:   eth0: neta@30000 [PRIME]

rm-rf_

Naturally, as soon as I post I figure it out. USB Drive was plugged into the wrong USB port. It should be connected to the white USB port by the WAN.

stephenw10

Yup some USB drives don't play nicely with one of the ports. It always the same though.