Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Lanner NCA-1010 doesn't start after 2.4.1 to 2.4.2

Problems Installing or Upgrading pfSense Software

1 Posts 1 Posters 376 Views

Log in to reply

W

Wordo
last edited by

Hi,

I have a NCA-1010 as a remote probe running fine since 2.3.0. Also upgrade to 2.4.0 went fine, but today I pushed from 2.4.1 to 2.4.2 but it doesn't came up again.
Anyone else experiencing this behavior?

ATM no chance to power cycle the device remotely.

Thanks!
1 Reply Last reply
Reply Quote 0

Copyright 2025 Rubicon Communications LLC (Netgate). All rights reserved.

1 / 1