OPT1 Interface
-
Having a little trouble getting my second WAN to work. Ping is unsuccessful.
On the Interfaces>OPT1 tab, section for IP Configuration. what goes in the IP address and gateway input boxes if my connection information is as follows…
IP Address: 192.168.2.5
Broadcast: 192.169.2.255
subnet mask: 255.255.255.0
Default Route: 192.168.2.1
Primary DNS: 192.168.2.1
2nd DNS: 68.87.64.146Thanks ahead of time.
-
Having a little trouble getting my second WAN to work. Ping is unsuccessful.
Did you create firewall rules on the OPT1 tab?
Per default everything gets blocked.
(or do you want to use this interface only for outbound traffic? then you dont need a rule)On the Interfaces>OPT1 tab, section for IP Configuration. what goes in the IP address and gateway input boxes if my connection information is as follows…
IP Address: 192.168.2.5
Broadcast: 192.169.2.255
subnet mask: 255.255.255.0
Default Route: 192.168.2.1
Primary DNS: 192.168.2.1
2nd DNS: 68.87.64.146Thanks ahead of time.
255.255.255.0 translates into /24
For the DNS entries:
http://forum.pfsense.org/index.php/topic,11033.0.html -
Your broadcast and subnet addressing do not match. One of those is wrong.
-
Your broadcast and subnet addressing do not match. One of those is wrong.
That is my fault, I should have posted this in the Virtualization Section.
GruensFroeschli:
Thanks for the advice, I dont think I did this time. The first time around it worked fine, than broke it ;D followed the same walk through, must have missed a step. i'll report back.