Pfsense 2.4 transparent bridge

[rforrestjr]

I need to place this as bridge so i can use the filtering, and other tools just no nat

Turn off Nat

set net.link.bridge.pfil_bridge and set the value to 1

Bridged my Wan and Lan, set Ip and rules to get to the webpage.

My setup goes

ISP–->Gateway---->PFsense Wan Port---->Out to Lan from lan port

It still does not filter, I know it can be done i had untangled doing this fine.

[stephenw10]

What do you have net.link.bridge.pfil_member set to?

That needs to be set to 1 to filter traffic on the bridge member interfaces which it sounds like you're trying to do. And setting both to 1 is probably not required. Do have the bridge interface assigned even?

Do you actually need a bridged setup? You can disable NAT without bridging but you still route.

Steve