OLSR mesh networking q.

pcatiprodotnet

Can OLSR be configured to function using MACs instead of IPs to direct traffic ?
(obviously with pfSense set to Bridge mode)
And, can it be set to use the first wlan card for 2.4ghz 802.11g local AP traffic and the second wlan card for 5ghz 802.11a mesh backhaul and pass-through traffic?
If so, I know the gui hasn't been developed for it yet, so any config file help is appreciated.
Thanks, -pc

jeroen234

olsrd is used for routing so it will always use ipadresses what you want is olsrd on the second lancard and no olsrd on the first card
open a shell

cd /usr/local/etc
replace 10.141.250.0 255.255.255.0 with you lan network or wireless network or add both
remove 0.0.0.0 0.0.0.0 if you don't want the olsrd mesh to use youre internet conection

nano olsrd.conf
DebugLevel 2
IpVersion 4
ClearScreen yes

HNA IPv4 routes

syntax: netaddr netmask

Example Internet gateway:

0.0.0.0 0.0.0.0

Hna4
{
# Internet gateway:
# 0.0.0.0 0.0.0.0
# more entries can be added:
# 192.168.1.0 255.255.255.0
#10.141.254.0 255.255.255.0
10.141.250.0 255.255.255.0
0.0.0.0 0.0.0.0
}

close file with control + X

start olsr with
olsrd -i xl0 >> /dev/null &
replace xl0 with you second wireless interface

pcatiprodotnet

it will always use ipadresses
Is there any way to get OLSR to pass regular ethernet (MAC) traffic such as using VPN over OLSR set up in pfSense, or other trick?
Another possibility if the above won't work: Can pfSense in Bridge mode also do "spanning tree protocol"? If so, is this possible solution worthy?
Thank you for the helpful replies,
[ thread continued/merged here: http://forum.pfsense.org/index.php?topic=657.0
-Pete