A problem to set wan gateway

mazz

i install the pfsense to the harddrive. the computer has 2 interfaces ,fxp0 is wan fxp1 is lan.
i set the static ip and gateway to the wan interface
Static IP configuration
IP address 218.10.111.189 /28
Gateway 218.10.111.185
and press save.
then when i go to the Diagnostics page ,and Execute command ifconfig
it reports :
$ ifconfig
fxp0: flags=8843 <up,broadcast,running,simplex,multicast>mtu 1500
options=8 <vlan_mtu>inet6 fe80::210:5cff:feb3:a54e%fxp0 prefixlen 64 scopeid 0x1
inet 218.10.111.189 netmask 0xfffffff0 broadcast 218.10.111.191
ether 00:0d:87:bd:8e:f1
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
fxp1: flags=8843 <up,broadcast,running,simplex,multicast>mtu 1500
options=8 <vlan_mtu>inet 192.168.0.7 netmask 0xffffff00 broadcast 192.168.0.255
inet6 fe80::290:27ff:fe7b:182d%fxp1 prefixlen 64 scopeid 0x2
ether 00:90:27:7b:18:2d
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
pflog0: flags=100 <promisc>mtu 33208
enc0: flags=0<> mtu 1536
lo0: flags=8049 <up,loopback,running,multicast>mtu 16384
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x5
pfsync0: flags=41 <up,running>mtu 2020
pfsync: syncdev: lo0 maxupd: 128

in the fxp0 paragraph ,there is no route infomation!
how dose this happen?
thank you all</up,running></up,loopback,running,multicast></promisc></full-duplex></vlan_mtu></up,broadcast,running,simplex,multicast></full-duplex></vlan_mtu></up,broadcast,running,simplex,multicast>

sullrich

route get default

But beware, multi wan from a shell most likely does not function how you think. PF does multi wan.

hoba

Or from gui: diagnostics>routes

mazz

i fonud it in the Diagnostics>Route

Diagnostics: Routing tables

Name resolution Enable
Enable this to attempt to resolve names when displaying the tables.

Note: By enabling name resolution, the query should take a bit longer. You can stop it at any time by clicking the Stop button in your browser.

IPv4
Destination Gateway Flags Refs Use Mtu Netif Expire
default 218.10.111.185 UGS 0 2 1500 fxp0
127.0.0.1 127.0.0.1 UH 0 0 16384 lo0
192.168.0 link#2 UC 0 0 1500 fxp1
192.168.0.86 00:0d:87:bd:8e:f1 UHLW 1 193 1500 fxp1 1140

it shows the gateway was correct.
i halt the pfsense yesterday. and after i press the bottom to open it this morning , it works.