Intallation onto Transcend IDE Flash

hoba

Try the latest snapshot. It runs a newer freebsd. maybe that version works better for you.

rklopoto

Well, so far I've disabled DMA, and ACPI, still get basically the same result. I'm loading the snapshot from April 05 2007 and right now it's hanging even earlier (/mnt/etc). I'll keep playing with this more tomorrow morning.

sai

Quite a few people using flash memory instead of hard disks for the same reasons. However that is a very large memory.

I have had success with old 128 and 256MB's CF memory using PCI to flash adapters. Had problems getting a high speed (it was 10x or maybe 14x ?) memory recognised but you seem to be past that stage.

rklopoto

Well, heres a little bit of an update, but I'm no closer to having an install done.

I used the snapshot that says its from 3-27-2007. I get to the boot menu and exit that to get to a prompt. I type:

unset acpi_load
set hint.acpi.0.disabled=1
set hw.ata.ata_dma=0
set hw.ata.atapi_dma=0
boot

It then boots into the install, and I format the disk, etc…. It now gets to 62%, albeit very slowly. I get hard drive activity, and the CDROM drive reads very slowly, but it is installing. It takes several minutes to get to that point. Once it hits 62%, it just reboots on its own. That's better than 41%, but not 100%.

I have also tried making smaller partitions to see if that matters, but it doesnt seem to.

I'm stumped.

sai

Did you try turning off DMA , unwanted floppies, SCSIs etc in the BIOS?

rklopoto

@sai:

Did you try turning off DMA , unwanted floppies, SCSIs etc in the BIOS?

As far as I could tell, everything in the BIOS was off. At one point, I even turned off the IDE controller accidentally. I'm kind of at a loss. My next step is to try a different model motherboard to make sure it's not an inconsistency there. Right now the machine is running 1.0.1 on the Quantum HDD, so at least I have something.

hoba

You only disabled these settings in the bios? Did you try to disable them from the kernel on bootup? See http://wiki.pfsense.com/wikka.php?wakka=BootOptions how to do this.

joebarnhart

@hoba:

You only disabled these settings in the bios? Did you try to disable them from the kernel on bootup? See http://wiki.pfsense.com/wikka.php?wakka=BootOptions how to do this.

Do you mean something other than what the OP wrote in reply #4? Looks like he covered that to me.

hoba

Oops, sorry, missed that post in between. Sometimes it's hard to follow threads if they have become a bit longer and you try to read/answer all of them ;)

rklopoto

Thanks to those who have helped out so far.

I don't know if what I just did is good news or not:

I put the flash card in a Dell GX110 instead, and did an installation onto the flash card. It took a little time, but it went through without a problem.

I took that flash card, and put it back into the GX260 and it booted up. I walked away from it for a little while, and I had the following message on the screen when I came back.

ad0: timeout - write_DMA retrying (1 Retry Left) LBA=5665679

I'm thinking the GX260 doesn't like something about the flash card, or something is still enabled in the BIOS that I don't see.

I rebooted the GX260 with the flash card and disabled the DMA and ACPI again. I'm gonna keep watching it and see if the error comes back.