Nat and Filtered Bridge
-
I have Filtered bridge Ethernet->-Ethernet and Traffic Shaping
How i can NAT specific IP addresses?Example i have host 10.0.0.25
pfSense - 10.0.0.3
Virtual IP - 10.0.0.30I want NATting HTTP
from 10.0.0.25 ->trough (lan) side-> 10.0.0.3 ->as (wan) side-> 10.0.0.30If it's possible - how detailed this make?
VirtualIP type, wan or lan side, NAT rule on lan or wan side? …Pls help, or knock where look?
-
Can't make rule - all variant's not worked :'(
icmp 10.0.0.21:512 -> 194.87.11.112 0:0
tcp 10.0.0.3:80 <- 10.0.0.21:4977 FIN_WAIT_2:FIN_WAIT_2
tcp 10.0.0.3:80 <- 10.0.0.21:4979 FIN_WAIT_2:FIN_WAIT_2
tcp 10.0.0.3:80 <- 10.0.0.21:4990 FIN_WAIT_2:FIN_WAIT_2
tcp 10.0.0.3:80 <- 10.0.0.21:4996 ESTABLISHED:ESTABLISHED
tcp 10.0.0.3:80 <- 10.0.0.21:3007 FIN_WAIT_2:FIN_WAIT_2
tcp 205.189.214.250:80 <- 10.0.0.21:3015 CLOSED:SYN_SENT
tcp 10.0.0.21:3015 -> 10.0.0.3:50325 -> 205.189.214.250:80 SYN_SENT:CLOSED
udp 10.0.0.21:3002 -> 10.0.0.3:51822 -> 192.168.2.20:53 SINGLE:NO_TRAFFIC
udp 10.0.0.21:1103 -> 10.0.0.3:52415 -> 192.168.2.20:53 SINGLE:NO_TRAFFIC
udp 192.168.2.20:53 <- 10.0.0.21:1103 NO_TRAFFIC:SINGLE
udp 192.168.2.20:53 <- 10.0.0.21:3002 NO_TRAFFIC:SINGLE
udp 192.168.2.22:53 <- 10.0.0.21:1103 NO_TRAFFIC:SINGLE
udp 192.168.2.23:53 <- 10.0.0.21:3002 NO_TRAFFIC:SINGLE
udp 10.0.0.255:137 <- 10.0.0.21:137 NO_TRAFFIC:SINGLE
udp 10.0.0.21:1103 -> 10.0.0.3:62050 -> 192.168.2.22:53 SINGLE:NO_TRAFFIC
udp 10.0.0.21:3002 -> 10.0.0.3:53304 -> 192.168.2.23:53 SINGLE:NO_TRAFFIC
udp 10.0.0.21:137 -> 10.0.0.3:53734 -> 10.0.0.255:137 SINGLE:NO_TRAFFICRule NAT
interface:WAN src:10.0.0.21/32 dst:ANY trans:INTERFACE ADDRESS
all ports=any(blank)This rule i copy from default and change src