OpenNTPD configuration (v. 1.2-RC2 embedded)
-
small bug;
I enabled the "OpenNTPD service" yet it does not display under "Status: Services".
I used the command "ps -aux" and found;
_ntp 91800 0.0 0.2 1344 1056 ?? S 8:50AM 0:00.07 ntpd: ntp engine
root 91801 0.0 0.2 1376 1052 ?? Ss 8:50AM 0:00.00 ntpd: [priv] (ntSo, appears to be running but not shown on the GUI.
PM
-
It doesn't show as a service in earlier versions of 1.2 either.
-
I think it would be helpful to list "selected - on" services. Would this be difficult to do?
-
I applogize this is slightly off topic.
I was reading this thread trying to figure out if i may have an issue and find that the ntp engine is running however it hasnt updated in two days. the last time it updated was when i installed pfsense
Sep 24 21:37:42 ntpdate[251]: adjust time server 219.117.196.238 offset -0.061082 sec
I searched for a little insite into how offen it updates and possible problems.
I know the clock wasnt that far off but in two days there should be some drift to show in an update.