Netgate Discussion Forum
    • Categories
    • Recent
    • Tags
    • Popular
    • Users
    • Search
    • Register
    • Login

    Traffic shaping flakey, Status -> Queues not loading

    2.0-RC Snapshot Feedback and Problems - RETIRED
    5
    7
    3.2k
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • S
      stechnique
      last edited by

      Hey folks,

      Using snapshot 1410 from today October 1st, I was able to configure the traffic shaper by removing the RED tags in each queue (and the dedicated links wizard wasn't creating all the proper WAN queues so I added those manually as well).
      I have some hiccups on my VoIP calls when I run a bandwidth speed test when I start and finish the upload portion. I'm trying to see queue status to better monitor what's going on, but the queue status is not loading. Whenever I go to the Status -> Queues page, the bars do not load, and the system web server stops responding for at least 60 seconds even if I close the page and try to log back on to the webGUI. After a while (60 to 120 seconds) the web servers starts loading pages again.

      Tested on IE7, Firefox 2, Firefox 3, Safari 3…
      What's up?

      1 Reply Last reply Reply Quote 0
      • B
        black0ut
        last edited by

        Just wanted to confirm that this bug is still here.

        Using 1.3-ALPHA-ALPHA
        built on Mon Oct 6 22:00:43 EDT 2008.  Status-> Queues only loads the first queue, then hangs.  Also, the wizard for multi-wan kills the configuration, and I had to reinstall completely to get back into my box.

        1 Reply Last reply Reply Quote 0
        • E
          eri--
          last edited by

          Did the Status->Queues lock your browser ?

          about the multiwan wizard they function normally they just need red be removed from the config(for now) but i will take care of that.

          1 Reply Last reply Reply Quote 0
          • B
            black0ut
            last edited by

            @ermal:

            Did the Status->Queues lock your browser ?

            about the multiwan wizard they function normally they just need red be removed from the config(for now) but i will take care of that.

            Yea, I browsed farther back in this forum and saw that disabling red from each and every queue fixes it.  The status-> queues doesn't lock the browser.  Status bar says transferring from xx.xx.xx.xx, but the web server on the pfsense box hangs until you close status-> queues and wait about a minute.  Is there a debug log I can activate/see?

            I thought it might be the wizard, so I manually configured a traffic shaper config with only a few queues, and that still made the web server hang.

            I've also started with a fresh installation of the same release, still got the same problem.

            1 Reply Last reply Reply Quote 0
            • L
              lagreca
              last edited by

              I have the same problem.  Sometimes when viewing queues I get locked out of the webUI for a few minutes.  This appears to be a bug with pfSense, and has been around for a while.

              1 Reply Last reply Reply Quote 0
              • E
                eri--
                last edited by

                Status -> Queues is now fixed so you can use it.

                1 Reply Last reply Reply Quote 0
                • X
                  XToni
                  last edited by

                  How many queques can we use in 2.0 ?

                  1 Reply Last reply Reply Quote 0
                  • First post
                    Last post
                  Copyright 2025 Rubicon Communications LLC (Netgate). All rights reserved.