1.2.3-RC3 to 1.2.3-RELEASE breaks WAN-OPT1 bridge?
-
I upgraded to the RELEASE version from the last release candidate - the upgrade process went fine except that my WAN-OPT1 bridge seems to allow traffic in, but not out, after the installation. No obvious reason for this that I can see so far.
A separate RC3 to RELEASE upgrade on an embedded Alix system (without an OPT port) worked fine.
-
Fixed now.
I had entered a Gateway address to the OPT1 IP configuration when I was getting the WAN-OPT1 bridge working under the prior RC3 version.
Clearing the Gateway address field seems to have fixed the problem.