System Crash when Enable OPT1

[wick0704]

Hi..

I tried to install 2.0 beta version and all looking good. But when I Enable OPT1(PCI Wireless card: D-Link DWA-510). The system hang and crash… It's seem Driver issue. For you reference.!

[Guest]

Hi,

I have the same problem, there is a console error:

ral0: need multicast update callback
..
rt2561fw: could not load firmware image…

Do you found a solution?

[Guest]

I reinstalled and I have attached a screenshot of the error in console

[jimp]

It may help to type "bt" at that prompt and get a backtrace as well.

[_igor_]

BTW, is there a way to get the output in a file to send it after a reboot? Or only catch the output via serial? Its maybe off topic, but nice to know… Thanks

[jimp]

Right now the only way is serial. I don't think anyone has gotten around to adding dumpdev/textdump support to 2.0 yet. I meant to a month or so ago but got sidetracked.

[Guest]

OK, now Im back home, resintall pfsense

2.0-BETA1
built on Thu Dec 31 08:54:26 EST 2009

Enable Wifi on OPT1, crash again, and here are the screenshots

I hope this could be useful

Regards
Alfredo

[jimp]

Looks like something broken in the ral driver when interacting with your card/chipset.

Does this same card work in pfSense 1.2.3?

Unfortunately there isn't much that pfSense can do about driver issues, as the drivers are a part of FreeBSD.

http://doc.pfsense.org/index.php/Policy_on_FreeBSD_issues

[cmb]

Sounds like the same thing someone reported on the mailing list recently. I don't have any ral cards to try to see what might be triggering that, and report it upstream to get fixed. If someone would like to contribute a card to the cause, email me (cmb at pfsense dot org).

[Guest]

I'm sorry but I think  I'm a little far from you, I'm in Chile, so could be to expensive for me to send a card to you.

I tried now with a Linksys PCI WiFi card, and it works, I set up it in AP mode, but it doesnt work as AP, its visible, I can conect to it, it provides IP via DHCP, but no routing and is not possible to connect to PFsense BOX by this interface, this is the configuration:

• <opt1><descr>WiFi</descr>
    <if>ral0</if>
• <wireless><standard>11g</standard>
    <mode>hostap</mode>
    <protmode>off</protmode>
    <ssid>PF</ssid>
    <channel>1</channel>
    <authmode><txpower>99</txpower>
    <distance>- <wpa><macaddr_acl><auth_algs>1</auth_algs>
    <wpa_mode>2</wpa_mode>
    <wpa_key_mgmt>WPA-PSK</wpa_key_mgmt>
    <wpa_pairwise>CCMP TKIP</wpa_pairwise>
    <wpa_group_rekey>60</wpa_group_rekey>
    <wpa_gmk_rekey>3600</wpa_gmk_rekey>
    <passphrase>12345678</passphrase>
    <ext_wpa_sw><enable></enable></ext_wpa_sw></macaddr_acl></wpa></distance></authmode></wireless>
    <enable><spoofmac><ipaddr>172.27.101.1</ipaddr>
    <subnet>24</subnet></spoofmac></enable></opt1>

Regards
Alfredo