Setup wizard fails after ntp setting

Efonnes

There was a patch to fix the disabled state on optX interfaces, but it made it impossible to save settings on the pages for configuring wan or lan, since they don't have that checkbox. This has already been fixed, but some snapshots did get built before the fix was committed.

For that particular issue if you want to manually apply the fix, look for these lines in usr/local/www/interfaces.php:


 			Enable

 				 onClick="show_allcfg(this);">
 			**Enable Interface**

And change it to look like this:


 			Enable

 				 onClick="show_allcfg(this);">
 			**Enable Interface**

Images from the 5th and later should have the fix.

As for the other issues, I know nothing about those.

Peter Kaagman

lol…. timing is all it seems....
Made the change and I can now change the settings for the WAN interface... thanks o

further on that other issue:
Had to reboot the box to get access again.... noticed the LAN inface had reset itself to its initial IP configuration (192.168.1.1). Have to change this because my WAN interface is on a 192.168.1/24 network to.

dr.diesel

@Efonne:

Images from the 5th and later should have the fix.

As for the other issues, I know nothing about those.

Note I have this exact same problem with the 2g nanobsd version dated the 6th.

Thanks

keylevel

I've just had the "No page assigned to this user! Click here to logout." message.

When I reboot I now get lots of "XML error: no pfsense object found!" messages on the console interface.

This was with pfSense-2.0-BETA1-512mb-20100307-1243-nanobsd.img.gz.

wallabybob

@keylevel:

I've just had the "No page assigned to this user! Click here to logout." message.

When I reboot I now get lots of "XML error: no pfsense object found!" messages on the console interface.

I had the same problem with pfSense-Full-Update-2.0-BETA1-20100308-2108.tgz.

I checked and /usr/local/www/interfaces.php had the patch in Efonne's reply.

Efonnes

That was only related to the last part of what was mentioned in the first post. The rest are other issues.

wallabybob

The originally reported issue also happens on the build pfSense-Full-Update-2.0-BETA1-20100221-0542.tgz

From console, reset to factory defaults then set IP of LAN interface, then connect to web GUI.

mppkll

@keylevel:

I've just had the "No page assigned to this user! Click here to logout." message.

When I reboot I now get lots of "XML error: no pfsense object found!" messages on the console interface.

This was with pfSense-2.0-BETA1-512mb-20100307-1243-nanobsd.img.gz.

Same issue with "pfSense-2.0-BETA1-1g-20100309-0142-nanobsd.img.gz"

cmb

ticket opened earlier
http://redmine.pfsense.org/issues/show/414

Efonnes

A fix has been committed for this issue. The snapshot after the first one available after this post should probably have the fix.