Some problems with USB stick

Tamriel

CF i mean USB stick
I try almost all available USB ports (burn embedded PF)
Maybe i bought none legal devise

Tamriel

the same bag on both sticks :(
in addition first one is new …

Безымянный.png
Безымянный.png_thumb

stephenw10

The Kingston DTmini10 is a USB flash drive. Spec sheet, pdf.
It should work though. ???

Steve

Tamriel

it's a miracle after i clear my kingston (scan with HDD regenerator ) i can burn the embedded PF(in progress and no bags yet ):)
Fantastic :)

Thx so mush :)

is it difference between 2GB and 4 GB embedded images ?

jimp

CF, USB, shouldn't really matter. Only major difference is the PC interface. Same notes about wear-down would apply, and there have been cases of "ghost shift" shoddy media that appear to be branded but are falsified.

Check this guy's report on SD media:
http://www.bunniestudios.com/blog/?p=918

It could be a BIOS bug, but that is doubtful if you have trouble writing it on two devices (the PC you're imaging it from, and also the firewall device).

jimp

Running a scan on that may have caused some defective sectors to be remapped or removed from service on the media, but it probably isn't a long-term solution. It may work for a while though.

Tamriel

на встроенной версии pfsense оно может снова поломаться ?

on an embedded version of pfsense it can go wrong again?

jimp

Eventually, yes, but it would take longer to show up since there are less writes to the embedded version.

Tamriel

current hdd is a piece of %% :)
Nov 2 20:11:23 last message repeated 5 times
Nov 2 20:03:08 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 20:00:02 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 20:00:02 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 20:00:01 check_reload_status: check_reload_status is starting
Nov 2 19:59:00 last message repeated 5 times
Nov 2 19:50:44 last message repeated 5 times
Nov 2 19:41:26 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:38:20 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:38:20 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:37:49 kernel: g_vfs_done():ad0s1a[WRITE(offset=1360723968, length=16384)]error = 5
Nov 2 19:37:49 kernel: ad0: FAILURE - WRITE_DMA status=51 <ready,dsc,error>error=84 <icrc,aborted>LBA=2657743
Nov 2 19:37:49 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:37:49 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:37:18 kernel: g_vfs_done():ad0s1a[WRITE(offset=1360723968, length=16384)]error = 5
Nov 2 19:37:18 kernel: ad0: FAILURE - WRITE_DMA status=51 <ready,dsc,error>error=84 <icrc,aborted>LBA=2657743
Nov 2 19:37:18 last message repeated 3 times
Nov 2 19:35:14 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:35:14 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:33:41 kernel: g_vfs_done():ad0s1a[WRITE(offset=1360723968, length=16384)]error = 5
Nov 2 19:33:41 kernel: ad0: FAILURE - WRITE_DMA status=51 <ready,dsc,error>error=84 <icrc,aborted>LBA=2657743
Nov 2 19:33:41 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:33:41 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:33:10 kernel: g_vfs_done():ad0s1a[WRITE(offset=1360723968, length=16384)]error = 5
Nov 2 19:33:10 kernel: ad0: FAILURE - WRITE_DMA status=51 <ready,dsc,error>error=84 <icrc,aborted>LBA=2657743
Nov 2 19:33:10 last message repeated 3 times
Nov 2 19:32:08 last message repeated 2 times
Nov 2 19:30:04 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:26:27 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:26:27 kernel: vnode_pager_putpages: residual I/O 4096 at 5
Nov 2 19:25:26 last message repeated 2 times
Nov 2 19:24:24 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:22:20 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:21:18 kernel: vnode_pager_putpages: residual I/O 4096 at 5
Nov 2 19:20:16 last message repeated 2 times
Nov 2 19:19:14 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:19:14 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
Nov 2 19:19:13 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=10161807
Nov 2 19:16:08 kernel: vnode_pager_putpages: residual I/O 4096 at 5
Nov 2 19:14:04 kernel: ad0: WARNING - WRITE_DMA UDMA ICRC error (retrying request) LBA=2657743
g_vfs_done():ad0s1a[WRITE(offset=1360723968, length=32768)]error = 5</icrc,aborted></ready,dsc,error></icrc,aborted></ready,dsc,error></icrc,aborted></ready,dsc,error></icrc,aborted></ready,dsc,error>

jimp

May not be a POS, could be the controller/BIOS. Disable DMA (check the doc wiki for how) and try again.

Tamriel

I try to change IDE cable , maybe it helps

stephenw10

I had forgotten my own experience with CF.
You MUST disable udma in the bios if you are using compact flash and BSD. PIO mode only. Something about compact flash not fully meeting the IDE spec, though it works fine under linux.
I'm not sure about USB but i'd try this first.

Steve

Tamriel

I repair my hard ( victoria , hdd regenerator,Low level Format) and change Ide cable
funny function
THX for conversation!

Nov 4 10:45:38 sshd[6791]: Accepted keyboard-interactive/pam for admin from 192.168.0.2 port 41079 ssh2
Nov 3 21:28:34 last message repeated 14 times
Nov 3 21:28:21 last message repeated 31 times
Nov 3 21:27:50 kernel: arp: 192.168.0.2 is on rl1 but got reply from 00:20:ed:69:37:f1 on vr0
Nov 3 21:27:50 php: : Processing -
Nov 3 21:27:50 php: : Processing start -
Nov 3 21:27:50 php: : Processing vr0 - start
Nov 3 21:27:50 check_reload_status: rc.linkup starting
Nov 3 21:27:49 kernel: arp: 192.168.0.2 is on rl1 but got reply from 00:20:ed:69:37:f1 on vr0
Nov 3 21:27:49 kernel: vr0: link state changed to UP
Nov 3 21:27:31 last message repeated 6 times
Nov 3 21:27:17 kernel: arp: 192.168.1.1 is on vr0 but got reply from 00:30:4f:69:73:3b on rl1
Nov 3 21:25:54 php: : Processing -
Nov 3 21:25:54 php: : Processing start -
Nov 3 21:25:54 php: : Processing rl0 - start
Nov 3 21:25:54 kernel: rl0: link state changed to UP
Nov 3 21:25:54 check_reload_status: rc.linkup starting
Nov 3 21:25:52 kernel: rl0: link state changed to DOWN
Nov 3 21:25:51 kernel: rl0: link state changed to UP
Nov 3 21:25:36 login: login on ttyv0 as root
Nov 3 21:25:34 check_reload_status: check_reload_status is starting
Nov 3 21:25:34 php: : Resyncing configuration for all packages.
Nov 3 21:25:33 dhcpd: For info, please visit http://www.isc.org/sw/dhcp/
Nov 3 21:25:33 dhcpd: All rights reserved.
Nov 3 21:25:33 dhcpd: Copyright 2004-2008 Internet Systems Consortium.
Nov 3 21:25:33 dhcpd: Internet Systems Consortium DHCP Server V3.0.7
Nov 3 21:25:33 php: : Creating rrd update script
Nov 3 21:25:29 dnsmasq[578]: read /etc/hosts - 2 addresses
Nov 3 21:25:29 dnsmasq[578]: using nameserver 192.168.1.1#53
Nov 3 21:25:29 dnsmasq[578]: reading /etc/resolv.conf
Nov 3 21:25:29 dnsmasq[578]: compile time options: IPv6 GNU-getopt BSD-bridge ISC-leasefile no-DBus no-I18N TFTP
Nov 3 21:25:29 dnsmasq[578]: started, version 2.45 cachesize 150
Nov 3 21:25:29 dhcpd: For info, please visit http://www.isc.org/sw/dhcp/
Nov 3 21:25:29 dhcpd: All rights reserved.
Nov 3 21:25:29 dhcpd: Copyright 2004-2008 Internet Systems Consortium.
Nov 3 21:25:29 dhcpd: Internet Systems Consortium DHCP Server V3.0.7
Nov 3 21:25:28 kernel: rl1: link state changed to UP
Nov 3 21:25:27 kernel: pflog0: promiscuous mode enabled
Nov 3 21:25:26 kernel: Trying to mount root from ufs:/dev/ad2s1a
Nov 3 21:25:26 kernel: ad2: 9541MB <wdc wd100eb-00csf0="" 04.01b04="">at ata1-master UDMA100
Nov 3 21:25:26 kernel: IPsec: Initialized Security Association Processing.
Nov 3 21:25:26 kernel: Timecounters tick every 1.000 msec
Nov 3 21:25:26 kernel: Timecounter "TSC" frequency 1462510354 Hz quality 800
Nov 3 21:25:26 kernel: uhub1: device problem (STALLED), disabling port 1
Nov 3 21:25:26 kernel: unknown: <pnp0c01>can't assign resources (memory)
Nov 3 21:25:26 kernel: speaker0: <pc speaker="">at port 0x61 pnpid PNP0800 on isa0
Nov 3 21:25:26 kernel: unknown: <pnp0303>can't assign resources (port)
Nov 3 21:25:26 kernel: vga0: <generic isa="" vga="">at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Nov 3 21:25:26 kernel: sio1: port may not be enabled
Nov 3 21:25:26 kernel: sio1: configured irq 3 not in bitmap of probed irqs 0</generic></pnp0303></pc></pnp0c01></wdc>