HAVP is failing the eicar test.

dvserg

Sir,
thanks for your immediate response, but it is not blocking those downloads. What should i do now ?

Ок.
Do you have squid in system? How configured squid & havp.

NM04

Sir,
yes i do have squid in the system. But i have disabled it. Iwill show u the settings.

Antivirus: HTTP proxy (havp + clamav)

Proxy mode: Parent for squid
Enable Forwarded IP: yes (checked)
Enable X-Forwarded-For: no (unchecked)
Block file if error scanning:yes (checked)
Scan images:yes
Scan media stream:yes

SQUID:
Proxy server: General settings

Transparent proxy:no(unchecked)
Allow users on interface:yes(checked)
Suppress Squid Version:yes (checked)
REST ARE UNCHECKED.

_igor_

Oh, you must enable squid. As you can see, havp is parent for squid. So it cannot work as expected. Good luck!

dvserg

@NM04:

Proxy mode: Parent for squid

!
You take pages from the squid.
For test:
1. Set HAVP normal mode
2. Squid don't must have transparent mode
3. Setup you browser to the HAVP proxy use (IP/Port)
4. Test EICAR site to download.

NM04

hi all,
thanks dvserg and igor for your response, i applied the suggestions of your, but unfortunately its still not working…
now i am trying to reinstall it. I did the uninstall first from WebGUI and from the command both. Now can any one tell me from where to reinstall it WebGUI or shell..??

Regards,
NM04

NM04

hi all,
i reinstalled the havp from shell (uninstalled from WEBGUI and shell), and now can any one tell me how start havp through shell ?

Thanks & Regards,
NM04

NM04

hi all,
The installation for HAVP from shell was a success, it didn't gave any errors. But when i executed freshclam it gave the following error:

/libexec/ld-elf.so.1:Shared object "libbz2.so.4" not found, required by "freshclam"

what should i do now ?
Thanks in advance.
NM04

_igor_

take a look at a libbz2.so.*, maybe you have a libbz2.so.3 or similar. Symlink that found version to the missing one and test again. Should help. Afterwards you will likely get new errors stating missing libs. Do the same with that corresponding errors. Test again. Good luck!

NM04

hi all,
thanks igor for suggestion, but i am new to this pfsense, and i don't know where that file (libbz2.so) exists. Please help me to make havp work on my pfsense.
If i install it from the webgui it installs the older version of havp which runs but fails the eicar test, and if installed from the shell it installs the latest version but don't runs and gives that error mentioned in previous post. If possible for any one please give me a step by step procedure for havp. Though i have tried everything in my scope of knowledge, but nothing worked for me.

Regards,
NM04

NM04

igor u were right i have libbz2.so which is linked to libbz2.so.3, and both are present, but i can't find the libbz2.so.4( the missing one), there is no such file by the name libbz2.so.4 . What should i do now ?