Problem "Network interface mismatch"on pfSense Beta 2.0 while importing settings
-
Anyone else has problem with importing setting from 1.2.3 to 2.0? Please confirm. I'm still getting this.
-
I have problem with boot panic
-
Anyone else has problem with importing setting from 1.2.3 to 2.0? Please confirm. I'm still getting this.
Can you send me your config privately so I can run some tests with it, to see if it's something specific to your config?
You can mail it to me at jimp (at) pfsense (dot) org
I have problem with boot panic
That has nothing to do with this thread. There are already threads for the boot panic issue on amd64.
-
I have this same problem. A upgrade from 1.2.3 works fine upon the first boot, but once it finishes the upgrade if you reboot again then it comes up with the network interface mismatch each time. If I install 2.0 and import the settings I'm getting the same interface mismatch. I have not changed any settings before rebooting when the error comes up. Even if I try to assign the interfaces after reboot it keeps in a loop with interface mismatch.
Andy
-
I have this same problem. A upgrade from 1.2.3 works fine upon the first boot, but once it finishes the upgrade if you reboot again then it comes up with the network interface mismatch each time. If I install 2.0 and import the settings I'm getting the same interface mismatch. I have not changed any settings before rebooting when the error comes up. Even if I try to assign the interfaces after reboot it keeps in a loop with interface mismatch.
Please e-mail me a copy of your 1.2.3 configuration so I can try to replicate the problem. Send it to jimp at pfsense . org.
-
I have this same problem. A upgrade from 1.2.3 works fine upon the first boot, but once it finishes the upgrade if you reboot again then it comes up with the network interface mismatch each time. If I install 2.0 and import the settings I'm getting the same interface mismatch. I have not changed any settings before rebooting when the error comes up. Even if I try to assign the interfaces after reboot it keeps in a loop with interface mismatch.
Please e-mail me a copy of your 1.2.3 configuration so I can try to replicate the problem. Send it to jimp at pfsense . org.
It has been sent. If you need anything else please let me know.
Thanks,
Andy -
OK I think I fixed this.
If you had the load balancer configured, the upgraded monitor IPs were accidentally getting created as interfaces. So the next reboot had interfaces that really didn't exist and had no physical hardware associated, so it believed there was a mismatch.
Hopefully the next new snapshot dated after this post (note: Not the one building now, the one after it!) should include the fix.
-
Ok thanks. I'll test tomorrow :).
Thanks,
Andy
-
Finally ;) hehe
I hope my 1st post was helpfuly. -
