Error message igb: Could not setup and receive structures
-
Hi,
Hopefully someone on here can help, I am attempting to install pfsense 2 BETA5 on a Quad core box, that has 2 x Intel Quad port 1GB NICs.
However when I try7 and configure a interface the console just pumps out the message:
igbX: Could not setup receive structures.
I have done a bit of digging around and it looks to be a problem with the number of cores and the igb driver, however does anyone know any work arounds to get get this working?
I saw some comments on tweaking the driver .c file, however as its on a pfsense box I am not sure if that's a good idea.
-
a fix for that went into snapshots today, upgrade tomorrow
-
well my pfsense boxes have both stopped working again, very frustrating.
Is the latest igb driver (http://downloadcenter.intel.com/Detail_Desc.aspx?agr=Y&DwnldID=15815&lang=eng&wapkw=%2882575+driver%29) in the latest pfsense build?
Not 100% sure what to do really, the internal broadcomms seem to be working fine, so is it possible to unload or not load the igb driver for now? As I can work with the 4 internal interfaces until the igb drivers issues are fixed.
-
Same problem, did you find a solution?
well my pfsense boxes have both stopped working again, very frustrating.
Is the latest igb driver (http://downloadcenter.intel.com/Detail_Desc.aspx?agr=Y&DwnldID=15815&lang=eng&wapkw=%2882575+driver%29) in the latest pfsense build?
Not 100% sure what to do really, the internal broadcomms seem to be working fine, so is it possible to unload or not load the igb driver for now? As I can work with the 4 internal interfaces until the igb drivers issues are fixed.
-
Try the modifications suggested here for /boot/loader.conf.local
http://redmine.pfsense.org/issues/1221
-
I have the same issue moving from an old November build to RC-1 and an em interface.