Wan default gateway is link#2?
-
You should be able to use your config file from 1.2.3 however there does seem to be some issues.
There is a problem with illegal characters. The config file for 2.0 cannot contain some characters and if it does it won't be read correctly so if you had an odd name for one of your interfaces or aliases that could explain it.Steve
-
thank you, i'll see if I can get it working tomorrow
-
ok I got 2.0 installed, and after struggling with it, I realized I had a partially bum network card
but I am still having troubles. One is I can't get wifi working without creating a bridge. I made the outgoing rules, and made the firewall rule like I would with 1.2.3 but it still does not work, though lan works good
and a very strange thing happened. I can't access admin with firefox. On my wired lan I can't get it with chrome, IE, but it times out with firefox
does the same thing when I try to access it on my laptop with wireless when they're bridged, it works in IE just fine. if I try to use it in firefox, it just times out. I switched to HTTP instead of SSL and it still does the same thing. does anyone have any idea?
-
Are you using https-connection? have you deleted the old certificate?
-
at first I thought that was it, but I switched it over to http and it still does the same thing
-
Then you'll have to wait until the smarter one's can help you
-
You've tried from two different machines?
Same version of Firefox?Weird! :-\
-
yup. One my desktop, on lan
other laptop on wlansame version of firefox on each one, IE and chrome accesses it great (and yes I checked proxy settings too, all no proxy)
well thank you everyone for hanging in there with me, but in the end this p-i-t-a attempt at 2.0 ultimately kicked my ass. I put a kne and a lne card (both dc driver) and even though it gives me this wierd thing about setting dc1 tx idle mode, it still works, loaded my old xml file and everything is working great under 1.2.3. keep up the good work and I hope that you can make things under 2.0 a little easier cause I could never get two seperate outgoing nat rules working even after adding the same nat and fw rules I would under 1.2.3
-
A bit late now but just for reference 'link#2' appears to be how pfsense refers to interfaces in the routing table. See image. It shouldn't be your default gateway though.
Steve
 -
well it 'twas, even after a full reload with 1.2.3. not sure how that partially bad nic caused it
-
well I finally figured the problem out. Wasn't a bad nic. I could ping google from wan, lan and wlan, but could not access with computers on each *lan. so, I reset my settings from scratch and started over, works great now
the internal routing mechanism stopped working right. Never sure what exactly was wrong, but somehow pfsense internally f'd up enough to partially route intermittently.
