Captative Portal & Bridge
-
Hi,
I could need some help on this setup, so first I want to show you my topology:
WAN<–vr0-->PFSENSE(Alix)
LAPTOP <--WLAN--> FRITZBOX<--vr1-->PFSENSE(Alix)
LAN<--vr2-->PFSENSE(Alix)So I have internet on vr0, a LAN on vr2, and a Fritzbox on vr1 with a laptop connected to it using Fritzbox Wlan.
What I would like to have is that all WLAN guests have to login via captative portal.
Thus I created a bridge on vr0, vr1 and vr2. Heres the first thing that I noticed, when I change the bridge config, e.g. that it just runs on vr0 and vr2,
I sometimes can't ping to the Internet from my laptop... but when I then restart pfsense, it works again.So after restart, the bridge seems to work... I then created a VLAN on vr1, and on this VLAN-connection a new Interface called OPT1.
This I want to run the captative portal on. So my Idea was to have an interface which captative portal needs for running. This interface is based on a virtual
VLAN connection, which is finally bridged to my LAN and WAN.Problem is... it doesn't work ;)
Does anybody have a hint on what's wrong in this setup - or even better have an easier idea or solution ? -
In addition, I got these errors:
php: : There were error(s) loading the rules: /tmp/rules.debug:46: syntax error /tmp/rules.debug:47: syntax error pfctl: Syntax error in config file: pf rules not loaded - The line in question reads [46]: nat on $WAN from $tonatsubnets port 500 to any port 500 -> 77.0.204.115/32 port 500
Thanks a lot for your help!
Juel