Esxi + rc2 = weekly reset of host machine ?
-
4.1 / latest build i could find on their official website ….
perhaps i should try the custom builds by dell
-
Have you installed VmWare tools on the Pfsense VM??
-
-
Thx :) Which type of virtual machine have you chosen??
-
i guess a regular 64-bit freebsd setup, using the e1000 nics
so far the old RC1 doesn't seem to cause any issues, so i'm still guessing something went wrong with the auto-update from rc1 to rc2
-
Reinstall on 32 bit freebsd and see if it betters the situation. Best advice I can give based on the information.
-
I'd double check your bios on that Dell to ensure you're running the latest suggested version. Make sure you also check the HCL on vmware.com for your version of ESXi (http://tinyurl.com/3pp2ynf). I've seen similar problems when there is a bad RAID card involved.
Sean
-
It ran fine for around 2 months … then "suddenly" it started.
But i doubt it is a hardware issue.
The reason i doubt this is because
The crashes allways happen on a saturday (today is the 3rd time in a row). Also it does not seem to be related with the update to RC2 as today the old RC1 VM crashed.I'm starting to think me or a collegue must have installed some package that is coded to do something on a saturday that causes the VM to go unresponsive .
What packages could do this ?
AFAIK we have the following installed:
squid + squidguard (they ran for 2 months without issues)
lightsquid (been installed for a couple of weeks without issues)
ntop (probably most recently installed package and most likely suspect ?) -
If your host is still unresponsive you're chasing the wrong problem, it's an ESX issue completely unrelated to the guest(s) if the host doesn't behave.
-
I had the issue with a windows 2008 machine on an early Vpshere snapshot. So not entirely….
-
i went over there today, it's a national holliday so nobody around needing internet. I reinstalled esxi and a clean install of pfsense using snapshot of june 12.
I used the dell custom esxi (it might have more up to date drivers for dell hardware).
Pfsense installed with minimal packages required (only squid and squidguard were added).Also @cmb:
i tried installing squidguard before squid was installed… This install did not complete giving an error bout a missing file (some squid config file).
I Manually installed squid. then squidguard reinstalled without issues.